rp-hal-boards/rp2040-hal/examples/pio_proc_blink.rs

63 lines
1.6 KiB
Rust
Raw Normal View History

//! This example toggles the GPIO25 pin, using a PIO program compiled via pio_proc::pio!().
//!
//! If a LED is connected to that pin, like on a Pico board, the LED should blink.
#![no_std]
#![no_main]
use cortex_m_rt::entry;
use hal::gpio::{FunctionPio0, Pin};
use hal::pac;
use hal::pio::PIOExt;
use hal::sio::Sio;
use panic_halt as _;
use rp2040_hal as hal;
#[link_section = ".boot2"]
#[used]
2021-10-18 20:52:01 +11:00
pub static BOOT2: [u8; 256] = rp2040_boot2::BOOT_LOADER_W25Q080;
#[entry]
fn main() -> ! {
let mut pac = pac::Peripherals::take().unwrap();
let sio = Sio::new(pac.SIO);
let pins = hal::gpio::Pins::new(
pac.IO_BANK0,
pac.PADS_BANK0,
sio.gpio_bank0,
&mut pac.RESETS,
);
// configure LED pin for Pio0.
let _led: Pin<_, FunctionPio0> = pins.gpio25.into_mode();
// PIN id for use inside of PIO
let led_pin_id = 25;
// Define some simple PIO program.
let program = pio_proc::pio!(
32,
"
.wrap_target
set pins, 1 [31]
set pins, 0 [31]
.wrap
"
);
// Initialize and start PIO
let (mut pio, sm0, _, _, _) = pac.PIO0.split(&mut pac.RESETS);
let installed = pio.install(&program.program).unwrap();
let div = 0f32; // as slow as possible (0 is interpreted as 65536)
let (mut sm, _, _) = rp2040_hal::pio::PIOBuilder::from_program(installed)
.set_pins(led_pin_id, 1)
.clock_divisor(div)
.build(sm0);
// The GPIO pin needs to be configured as an output.
sm.set_pindirs([(led_pin_id, hal::pio::PinDir::Output)]);
sm.start();
// PIO runs in background, independently from CPU
#[allow(clippy::empty_loop)]
loop {}
}