//! Continuously changes the color of the Neopixel on a Adafruit ItsyBitsy RP2040 board #![no_std] #![no_main] use adafruit_itsy_bitsy_rp2040::entry; use core::iter::once; use embedded_hal::timer::CountDown; use fugit::ExtU32; use panic_halt as _; use smart_leds::{brightness, SmartLedsWrite, RGB8}; use ws2812_pio::Ws2812; use adafruit_itsy_bitsy_rp2040::{ hal::{ clocks::{init_clocks_and_plls, Clock}, gpio::PinState, pac, pio::PIOExt, watchdog::Watchdog, Sio, Timer, }, Pins, XOSC_CRYSTAL_FREQ, }; #[entry] fn main() -> ! { let mut pac = pac::Peripherals::take().unwrap(); let mut watchdog = Watchdog::new(pac.WATCHDOG); let clocks = init_clocks_and_plls( XOSC_CRYSTAL_FREQ, pac.XOSC, pac.CLOCKS, pac.PLL_SYS, pac.PLL_USB, &mut pac.RESETS, &mut watchdog, ) .ok() .unwrap(); let sio = Sio::new(pac.SIO); let pins = Pins::new( pac.IO_BANK0, pac.PADS_BANK0, sio.gpio_bank0, &mut pac.RESETS, ); let led = pins.neopixel_data.into_mode(); pins.neopixel_power .into_push_pull_output_in_state(PinState::High); let timer = Timer::new(pac.TIMER, &mut pac.RESETS); let mut delay = timer.count_down(); let (mut pio, sm0, _, _, _) = pac.PIO0.split(&mut pac.RESETS); let mut ws = Ws2812::new( led, &mut pio, sm0, clocks.peripheral_clock.freq(), timer.count_down(), ); let mut n: u8 = 128; loop { ws.write(brightness(once(wheel(n)), 32)).unwrap(); n = n.wrapping_add(1); delay.start(25.millis()); let _ = nb::block!(delay.wait()); } } /// Convert a number from `0..=255` to an RGB color triplet. /// /// The colours are a transition from red, to green, to blue and back to red. fn wheel(mut wheel_pos: u8) -> RGB8 { wheel_pos = 255 - wheel_pos; if wheel_pos < 85 { // No green in this sector - red and blue only (255 - (wheel_pos * 3), 0, wheel_pos * 3).into() } else if wheel_pos < 170 { // No red in this sector - green and blue only wheel_pos -= 85; (0, wheel_pos * 3, 255 - (wheel_pos * 3)).into() } else { // No blue in this sector - red and green only wheel_pos -= 170; (wheel_pos * 3, 255 - (wheel_pos * 3), 0).into() } }