rp-hal-boards/rp2040-hal/examples/pio_side_set.rs
9names b81955c2a8
Prep for 0.4.0 release (#312)
* Update changelog for 0.4.0 release

* Enable rt feature for irq example in Cargo.toml

* Bump pio/pio-proc deps to 0.2.0, update pio examples

* Update BSPs to latest ws2812-pio, remove unused pio dep

* Fix usage of pio_proc in doc comment

* Clean up pio doc-example

* Update rp-pico to latest i2c-pio

Co-authored-by: Jan Niehusmann <jan@gondor.com>
2022-03-11 22:37:34 +11:00

63 lines
1.7 KiB
Rust

//! This example toggles the GPIO25 pin, using a PIO program compiled via pio_proc::pio!().
//!
//! If a LED is connected to that pin, like on a Pico board, the LED should blink.
//!
//! This example makes use of side setting.
#![no_std]
#![no_main]
use cortex_m_rt::entry;
use hal::gpio::{FunctionPio0, Pin};
use hal::pac;
use hal::pio::PIOExt;
use hal::Sio;
use panic_halt as _;
use rp2040_hal as hal;
#[link_section = ".boot2"]
#[used]
pub static BOOT2: [u8; 256] = rp2040_boot2::BOOT_LOADER_W25Q080;
#[entry]
fn main() -> ! {
let mut pac = pac::Peripherals::take().unwrap();
let sio = Sio::new(pac.SIO);
let pins = hal::gpio::Pins::new(
pac.IO_BANK0,
pac.PADS_BANK0,
sio.gpio_bank0,
&mut pac.RESETS,
);
// configure LED pin for Pio0.
let _led: Pin<_, FunctionPio0> = pins.gpio25.into_mode();
// PIN id for use inside of PIO
let led_pin_id = 25;
// Define some simple PIO program.
let program = pio_proc::pio_asm!(
".side_set 1", // each instruction may set 1 bit
".wrap_target",
" nop side 1",
" nop side 0",
".wrap",
);
// Initialize and start PIO
let (mut pio, sm0, _, _, _) = pac.PIO0.split(&mut pac.RESETS);
let installed = pio.install(&program.program).unwrap();
let div = 0f32; // as slow as possible (0 is interpreted as 65536)
let (mut sm, _, _) = rp2040_hal::pio::PIOBuilder::from_program(installed)
.side_set_pin_base(led_pin_id)
.clock_divisor(div)
.build(sm0);
// The GPIO pin needs to be configured as an output.
sm.set_pindirs([(led_pin_id, hal::pio::PinDir::Output)]);
sm.start();
// PIO runs in background, independently from CPU
#[allow(clippy::empty_loop)]
loop {}
}